Turn harvest residue into next season’s advantage.

Pair of 360 CHAINROLL corn header stalk rolls

FASTER RESIDUE BREAKDOWN

A CLEANER SEED ZONE

A SIMPLE HEAD UPGRADE

Play Video

OVERVIEW

Generally, a row can be installed in 20 to 30 minutes. Two experienced individuals can change out a row in approximately 15 minutes.

Yes. Many operators use the nozzle-body assembly for in-row herbicide application. By flipping the 360 UNDERCOVER body over, the nozzles are directed toward the ground.

There is no significant horsepower difference between 360 CHAINROLL and traditional intermeshing rolls. Test data indicates that OEM rolls require approximately 9 horsepower per row. 360 CHAINROLL requires approximately 9% to 10% more horsepower than a standard intermeshing-knife OEM roll because of the additional work performed on the stalk during the chaining process.

Soil and plant conditions naturally affect stalk-roll wear. Based on empirical testing, metallurgical choices and wear treatments, 360 CHAINROLL generally exceeds the service life of traditional and chopping rolls.

Testing across significant acreage and operating experience indicates that 360 CHAINROLL has not caused an increase in gearbox issues.

Yes, but make sure the residue knives are properly adjusted.

Yes. Checking the torque during routine maintenance is recommended.

Even with thorough testing throughout the supply chain, variations among corn heads can cause slight interference after installation.

If you hear a slight “pinging” noise during initial operation, rotate the castings 90 degrees on the shaft and re-torque them. If the noise remains after several rotations, contact your dealer or the 360 Yield Center support team for assistance.

It depends on the severity of the wear. The best solution is to complete a spindle update and correct the source of the problem.

360 Yield Center offers trash knives specifically designed to work with 360 CHAINROLL. The tolerances between the knife and roll are much tighter than with standard rolls.

Manufacturing variations may require the row-unit housing to be adjusted. Because 360 CHAINROLL is slightly larger in diameter than John Deere OEM rolls, it could interfere with the deck plates at the front or along the length of the roll.

To adjust the housing, loosen the mounting bolts at the rear and lift the front of the row-unit housing. Re-torque the housing mounting bolts and verify that the interference has been removed.

If this procedure does not resolve the noise after several rotations, contact your dealer or the 360 Yield Center support team for assistance.

Yes. If the mower blades are disengaged while operating a chopping head, residue can accumulate beneath the row unit until the slip clutches engage. Removing the rubber baffle separating the row units is recommended to help alleviate this problem.

Depending on the desired results, 360 CHAINROLL can be used with or without stalk-chopping mower blades. From an agronomic perspective, mower blades may not provide a significant advantage in stalk breakdown compared with using 360 CHAINROLL alone.

360 CHAINROLL will not have a dramatically different effect on the portion of the stalk remaining between the corn head and the ground. Stalk choppers are still recommended when tire wear is a concern.

Make Compatible Models
John Deere 600 Series 2012+ / 700 Series / C Series
John Deere 600 Series 2008–2012
John Deere 40/90 Series
Case IH 4000 Series
Geringhoff North Star
  • 360 CHAINROLL for Case IH or Geringhoff on 20" and 22" heads 2018–current, call Product Support to verify fit.
  • 360 YIELD hardware kits are required for use with Case IH and Geringhoff 360 CHAINROLL kits.
  • 360 CHAINROLL Residue Knives are required for use with Case IH and Geringhoff 360 CHAINROLL kits.
  • Check row unit gear box and shaft tolerances before installation and operation of CHAINROLL row kits.

FIND THE RIGHT FIT FOR YOUR OPERATION.