Fracture the full profile. Free the roots.

360 BULLET winged ripper point

BREAK MORE SOIL

OPEN ROOT ACCESS

USE YOUR TRACTOR

Play Video

OVERVIEW

In a field that is being ripped with 360 BULLET for the first time, you may experience a minimal need for more horsepower – generally around 5%. Once the field has been ripped with 360 BULLET, there is generally no difference in the horsepower required.

Ripping depth should be checked and adjusted field to field. The nose of the 360 BULLET extends an inch further than OEM ripper points and the wings are positioned lower. So it is likely that you could shallow the ripper and achieve the same operating depth as an OEM ripper.

360 BULLET is crafted from different materials to give you the best combination of wear and durability for all of your soil conditions.

360 BULLET HW

For high wear. It is a great choice for regions without rocks. Available for most V-style rippers with 1.25-inch shanks.

360 BULLET HD+

Similar high-wear characteristics and more forgiving in regions with rocks or stones. Available for most V-style rippers with 1.25-inch shanks.

360 BULLET HD

Fabricated with hardened steel and a cast nose cap. Available for:

Case IH / DMI 530, 730, 9300 Rippers / 1.5-inch Shank
Landoll 2410, 2430 Rippers / 1.25-inch Shank

360 BULLETs, with the wide wings, have more wear surface so we expect them to wear faster than traditional points. Remember that these points are fracturing 40% more soil than traditional points. So, expect somewhat, but not significantly more wear than OEM points.

Yes. No different than any ripper points. Optimum fracture and wear comes with a level ripper.

The points will fit on other models of rippers but there can be variances in the pitch and angle of the shank that can affect performance. So we only recommend running 360 BULLET points on our supported list of rippers.

No. The bolt should be able to be turned. This prevents strain on the sides of the point and binding against the shank.

Make Model Shank
Case IH 870, 875 and 690 1-1/4"
Kuhn Krause 4850 and 4855 1-1/4"
Salford 9700 CTS and 9800 DRH 1-1/4"
John Deere 510 and 512 1-1/4"
John Deere 2700, 2720 and 2730 1-1/4"
Landoll 2410 and 2430 1-1/4"
Case IH/DMI 530, 730 and 9300 1-1/2"

Before you order

  • Confirm your ripper model and shank size are included on the 360 BULLET compatibility chart. Points may fit other machines, but differences in shank pitch and angle can affect performance.
  • Select the right point for your field conditions: 360 BULLET HW is intended for high-wear conditions without rocks, while HD+ is better suited for fields with rocks or stones.
  • Inspect ripper shanks for excessive wear. A worn shank can prevent the point from seating correctly and cause the retaining bolt to bind.
  • Expect to check and adjust operating depth. The 360 BULLET nose extends approximately one inch farther than an OEM point, and its wings sit lower.
  • Make sure the ripper can be properly leveled. Correct leveling is essential for consistent soil fracture and even point wear.
  • Most operators can use the same tractor and gear as with conventional points, although a field’s first pass with 360 BULLET may require approximately 5% more horsepower.

FIND THE RIGHT FIT FOR YOUR OPERATION.